Any of these symptoms may indicate the need for engine diagnostic services or repairs to your vehicle:
- Engine light on
- Engine cranks but will not start
- Rough idling
- Pings or knocks when accelerating
- Decreased fuel efficiency
- Poor performance
Jim Ball Dealership technicians will inspect your engine system and perform engine diagnostics, providing you with a complete analysis of the current conditions and a repair cost estimate.
Based on the Diagnostic readings, some engine components that may need to be serviced include:
- Emissions
- Engine sensors, including: crank/cam sensor, oxygen sensor, airflow sensor, EGR sensor, MAP sensor, temperature sensor, throttle position sensor
- Coil packs
- Distributor cap and rotor
- Ignition wires
- Ignition module
- Fuel pump
FREE CHECK ENGINE LIGHT SERVICE
Is your engine light trying to tell you something? Why not find out? The “check engine” light on cars 1994 and newer could be directing you to problems with your emissions system or engine controls. Jim Ball Dealership’ “Check Engine Light” Service will make sure that little light doesn’t mean big problems. Includes:
- Retrieve and identify any codes stored within the vehicle’s on-board computer system
- Further diagnosis may be required
COMPUTERIZED ENGINE DIAGNOSTIC SERVICE
For vehicles that run but run poorly, stall, hesitate, suffer reduced gas mileage, or will crank but will not start. Jim Ball Dealership expert technicians will perform a special computerized diagnosis that will identify the problem. Includes:
- Road test
- Complete engine performance diagnostic test
- Fuel pressure test
- Visual inspection of emissions system and other underhood systems
- Retrieve computer codes to identify potential problem areas.
CHARGING, STARTING SYSTEM DIAGNOSIS
For engines that do not crank at all.
Includes the following:
- Remove battery clamps and test battery using computerized tester prior to testing starting and charging system
- Conduct alternator and starter system analysis
- Verify that system voltage exists at all alternator and starter points
- Recommended schedule: Inspection every 24,000 miles*
*”Recommended service intervals” reflect Jim Ball Dealerships recommendations. Always refer to the owner’s manual for your vehicle’s scheduled maintenance requirements.
